Raised pavement markers, pavement markers, aluminum pavement markers, hydrant markers, highway reflectors, adhesive pads, pavement marker lenses, road studs, reflective markers, road reflectors, solar powered road markers, butyl pads from K-Lite USA Inc.

Adhesives

The new PARR Adhesive Pad was developed specifically for the surface mount channelizer post and road marker industry. It is made up of high strength rubber and butyl compounds to withstand the harshest of road conditions. High Impact Resistance – The Adhesive Pad is proven to withstand high impact and not lose its adhesion to asphalt and other pavement type materials. Size: 4 x 4 x 1/8 in	Easy Installation – The adhesive pad is ready to use and is the fastest way to adhere any surface mount post or marker. No cure time or mixing required. All you do is peel the tape off and stick them to the pavement, then place the marker on it and apply pressure. THEY WILL SLIP AND SLIDE AFTER INSTALLATION AND WILL NOT HARDEN. IT WILL STAY RUBBERY AND TACKY.
TO REMOVE BUTYL PADS USE SCRAPER AND MINERAL SPIRITS. For use with: Pavement markers Temporary pavement markers Click here for Parr Butyl Pad Instructions. Click here for Parr Butyl Pad MSDS.

2 Part Epoxy:
This two part epoxy is specially formulated for the adhesion of raised pavement markers to asphalt or concrete surfaces. Equal parts of Part A and Part B are mixed together, applied to the bottom of the marker, and the marker is set using only hand pressure. One 2 gallon kit will set from 120 to 200 4X4 markers, depending on the texture of the pavement.